Acumen Seals & Pumps Logo

Seepex Pump Mechanical Seal Replacement

2026-11-19 • By Director, Acumen Seals & Pumps Limited
Share:

Seepex BN 5-6L pump label showing the model code and year of manufacture

Seepex progressive cavity pumps move sludge, slurries and thick process fluids across UK water treatment, food and chemical plants, and their shaft seals are a regular enquiry for us. We select and supply equivalent mechanical seals to suit Seepex pumps, including the BN block design range, the standard industrial pump in their line up.

Where the seal sits in a Seepex pump

A progressive cavity pump drives a helical rotor inside an elastomer stator, and the shaft seal sits at the drive end of the suction casing, sealing the plug in shaft where it leaves the drive side. On the BN range the seal is a single mechanical seal, though some builds run packed gland instead. When the seal wears, the pump weeps product around the shaft, and on abrasive duties a worn seal lets grit travel further into the pump. A planned change is far cheaper than a rebuild.

Identifying the seal your pump needs

Each Seepex model and size takes its own seal arrangement, so the pump label is the starting point. The full model code, such as BN 5-6L, plus the commission number and year of manufacture narrow it down, and a photo of the old seal, or the shaft and seat dimensions, settles it. The label at the top of this post is a real BN 5-6L, built in 2018, on a customer's site. We check every enquiry against the pump model before we quote, so listing Seepex here does not mean every variant is covered.

Materials for the duty

What the pump is moving decides the seal materials. Sludge and abrasive slurries want hard faces, silicon carbide against silicon carbide in most cases. Elastomers are matched to the product: EPDM for water based duties, FKM for oils and many chemicals, nitrile where the duty suits it. Metal parts are typically 316 stainless steel. Tell us the product, the temperature and any cleaning fluids, and we will confirm the materials before quoting.

Dry running kills seals and stators

Progressive cavity pumps rely on the pumped product for lubrication at the seal and the stator. Even a short dry run can cook the stator elastomer and crack the seal faces. If a pump has run dry, say so when you enquire, because the seal may not be the only part it needs.

What to send us

A photo of the pump label, a photo of the old seal if you have it, and a line on what the pump is moving. Email them to office@acumenseals.co.uk and we will come back with the equivalent seal and a price.

Related: Replacement seals by pump make

Common questions

What seal does my Seepex pump need?

The model code and commission number from the pump label narrow it down, and a photo of the old seal, or the shaft and seat dimensions, settles it. Send us the label photo and a line on what the pump handles and we will quote for the equivalent seal.

Can you supply seals for the Seepex BN range?

Yes. We select and supply equivalent mechanical seals to suit Seepex BN progressive cavity pumps, with face and elastomer materials matched to the duty. We confirm every selection against the pump model before quoting.

My Seepex pump ran dry. Is the seal the only part it needs?

Not always. Dry running damages the stator as well as the seal faces. Tell us it ran dry when you enquire and we will flag what else to check.

If this failure mode sounds familiar, these are the products and services that usually fix it.

A

Director, Acumen Seals & Pumps Limited

Published on 2026-11-19

45 years in engineering and 36 years in sealing. Andrew specifies, supplies and troubleshoots mechanical seals, FFKM elastomers and pump sealing systems for UK industry.

More about Andrew
#Seepex#progressive cavity pump#mechanical seal replacement#Seepex BN#sludge pumps

Share this article

Share: